How to configure vEdge via command line when attach to vManage

If you try and configure a Viptela device via the command line while a template is attached to it in vManage you get the following error:

Aborted: ‘system is-vmanaged’: This device is being managed by the vManage. Configuration through the CLI is not allowed.

To get around this you’ll need to call support because no one will give you the password needed.  But here are the commands that will let you over ride the vManage attached template.

# unhide viptela_internal
Password: ************   >>NOTE this password changes every time a new version of code is released

(config)# no system is_vmanaged

After this you can configure via the command line to your hearts content.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s