How to configure vEdge via command line when attach to vManage

If you try and configure a Viptela device via the command line while a template is attached to it in vManage you get the following error:

Aborted: ‘system is-vmanaged’: This device is being managed by the vManage. Configuration through the CLI is not allowed.

To get around this you’ll need to call support because no one will give you the password needed.  But here are the commands that will let you over ride the vManage attached template.

# unhide viptela_internal
Password: ************   >>NOTE this password changes every time a new version of code is released

(config)# no system is_vmanaged

After this you can configure via the command line to your hearts content.

Advertisements